Home > Products > Sure Cote Veneer Plaster

Sure Cote Veneer Plaster

Sure Cote Veneer Plaster is a hard working cementitious paste that is used to cover, smooth and protect application surfaces. The high performance compound is ideal for use on several surfaces including concrete, ceilings, gypsum board, wood and drywall. It leaves a smooth and seamless finish that rivals that of regular cement based coverage. It reduces the amount of paint that is need to cover newly fabricated walls because of it is excellent and resilient finish.

High Quality Enhanced Cementitious Material
Ideal for use on Concrete, Gypsum Board and Wood
Suitable for Interior and Exterior Use
Rock Hard
Abrasion Resistant

Available In:

22lb Box 70lb Box 70lb Bag

High Quality Enhanced Cementitious Material
Ideal for use on Concrete, Gypsum Board and Wood
Suitable for Interior and Exterior Use
Rock Hard
Abrasion Resistant
Excellent Adhesion
Available in Cement Bag and Box

Mixing Instructions:

Use clean potable water only in a clean container.
Measure equal amounts of water for each batch, approximately 7.50 - 9.50 litres per bag of 32 kilos of Sure-Cote to ensure uniformity. Mix each for the same length of time.
Add Sure-Cote slowly to mixing water under agitation and bring to a smooth lump free consistency; approximately 5 minutes.
Equipment used for mixing must be clean. A heavy duty drill and mud paddle capable of producing a minimum of 650 RPM under load can be used. Do not over mix as this can rapidly shorten open time.
Mix only enough material that can be used in one (1) hour as retempering with water will affect performance of Sure-Cote.

Surface Preparation:

To enhance adequate bond and optimum performance, surface should be structurally sound and must be free from dirt, grease, oil, dust or any foreign material which may prevent proper bonding

Application Suggestion

Apply Sure-Cote in two (2) coats. Trowel on first coat sufficiently to straighten wall, but do not trowel smooth. After the first coat sets, trowel on the second coat and smooth to a thickness of not less than 1.5mm or a maximum of 3mm.
Joints should be reinforced using a fiber mesh tape to increase flexural strength and reduce cracking.
Avoid intermixing batches.

Sure Cote Calculator

Find out how much product you will need based on square feet or square meters. Amounts needed may vary and will be determined by product usage, skill level in performing application, surface condition and level of dilution.

SQ FT

SQ M